Crown CDi 2|600

• BLU link No
• Channels 2
• Sensitivity (for full rated power at 8 ohms) 0.7V RMS
• Rated Power Output (per channel @ 4 ohms) 600W
• Analog Input Signal to Noise Ratio (ref. rated power, 100V, 20Hz – 20kHz) at 8 ohms) > 104dB
• THD (full rated power, 20 Hz – 20 kHz) 0.35%
• Damping Factor (20 Hz to 100 Hz) > 1000
• Frequency Response (8O, 20 Hz – 20 kHz) +/-0.5dB
• Crosstalk (below rated power) 20 Hz to 1 kHz > 80dB
• Input Impedance (nominally balanced, nominally unbalanced) 20 kO balanced, 10 kO unblanced
• Dimensions (inches) (W x H x D) (depth not including 1.3 inch front panel protrusion) 19 x 3.5 x 12.25
• Weight 14.56 lbs (6.6 kg)
• Power Supply Connector “Standard IEC type 320 inlet for detachable connector 100 240V~”

• DriveCore Technology Crowns proprietary DriveCore technology eliminates hundreds of components within each amplifier, reducing the variability of component values, increasing reliability, resulting in incredible audio fidelity from an efficient design.
• Network Control and Monitoring Through Harmans HiQnet Audio Architect software, the CDi DriveCore can be controlled, configured, and monitored through standard TCP/IQ network.
• DSP On-board Digital Signal Processor in each amplifier allows for custom configuration
• Input Router
• Input Delay Up to 1000ms
• Input Parametric EQ 8 band
• Crossover
• Output Parametric EQ 8 band
• Output Delay Up to 100ms
• LevelMAX™ Limiter
• BLU link (BL models only) Both receive and send channels over HARMANs 256 channel, fault-tolerant audio BUS, BLU link
• Direct Drive 70/100Vrms Output Each output channel is capable of provide either 70V or 100V for high impedance applications.
• Front-Panel Interface Completely configure the amplifier using an intuitive front-panel interface.
• GPIO/AUX Port Recall presets, mute channels, monitor faults, power on/off the amplifier, and more through a combined GPIO/AUX Port.  

Analog input, 2 Channel, 600W per Output Channel

CDi 2|600

The CDi DriveCore Series is an evolution in amplification, providing an impressive mix of high-performance; rich feature set, and competitive cost. Using technology derived from our flagship Installed Sound amplifier (Crown DriveCore Install series), the CDi DriveCore 2|600 offers streamlined functionality to work in almost any medium sized installation such as cinema, houses of worship, bars, lounges, and more. Designed for ease-of-use in a variety of applications, the 2|600 is a 2-channel amp that includes network control/monitoring, high-level DSP, front-panel interface, and support for driving up to 100Vrms speaker loads without requiring a transformer. The entire CDi DriveCore line comes pre-loaded with JBL speaker tunings to help make installations quicker and easier.

• Cutsheet